Masters Relief Enhancer

Enhance the reliefs of your stamped concrete

Masters Relief Enhancer has the same result as the colored release agent when making the print. That is to say, it makes it possible to reinforce the nuances by accentuating the reliefs of the stamped concrete.

Very easy to use, it comes in the form of a powder to be mixed with water. Once applied, the mixture makes it possible to catch up with imprinted concrete that is too dull or not sufficiently nuanced.

As part of the renovation of printed concrete, it is used after Masters Reno Concrete which unifies the support (see demonstration video below).

Use

Coverage: 150mL to be mixed with 5L of water to cover an area between 25m² and 30m² depending on the desired effect and the method of application

Application modes : wide brush or broom

Prerequisites

• Apply to a porous, unvarnished surface.
• Rinse the surface to remove any remaining loose release agent.
• Do not apply if there is a risk of rain within 24 hours.

Application

1. Prepare the mixture at the rate of 30mL of Relief Enhancer Masters per liter of water. Shake vigorously to ensure good homogenization. Remember to shake the mixture well during its application so that there is no sedimentation at the bottom.
2. Distribute the liquid mixture evenly with a soft-bristled broom or a wide brush. The mixture will be deposited in the negative reliefs (hollows, grooves ...). Leave to dry for 24 hours.
3. After drying, sweep to remove the excess which could affect the adhesion of the varnish.

Tip: If the result is not enough contrast or if you want to add another shade, it is possible to apply a second coat of the same or a different color.

Finishing

In order to protect your printed concrete against stains and external aggressions, but also to revive the colors, we recommend the application of a finishing varnish such as Masters Ecolex Sealer (aqueous, satin finish) or Masters Outside Sealer (solvent , glossy finish).